flip-sides


Features:

  • 1x dualswitch
  • 2x 3,5mm Inputs
  • 2x 3,5mm Outputs
  • for Audio and CV signals

Comes with 3mm Aluminium black front panel with signal white print

and BEFACO KNURLIES.

Cause every passive switch has a relatively short lifetime, the dualswitch is not soldered to pcb and could be easily replaced.


Works great with every stereo audio signal:

  • SYNTH´S STEREO OUTS
  • STEREO CHANNELS
  • STEREO GROUPS like FX, DRUMS, SYNTHS, VOCALS
  • STEREO FX SEND AND RETURNS
  • MONO FX with STEREO-OUTPUTS
  • AUDIO CV-PAN CHANNELS

Just change L + R signal with flip-sides and smile.


Works great with every CV, TRIG, CLK, GATE signal on:

  • DRUM MODULES
  • OSCILLATORS
  • FILTERS
  • SEQUENCERS
  • EFXs
  • LFOs
  • ENVs

Just change the rooting of two signals with flip-sides and get the most out of your existing eurorack system.

Human control over stereo image in the mix by simple dualswitch.

Just flip-sides and you will hear the difference!

I miss this function on every mixer with stereo channels, stereo FX sends, Subgroups AND – as well – on any DAW…

PATCHING EXAMPLES:


Use flips-sides to trigger 2 drum sounds!

You have two drum modules?

Now, you can simple change the Trig.-Seq. between two drum-modules with flip-sides.


Use flips-sides for CLK signals!

You have two FX-modules with CLK Input?

Now, you can simple change the CLK-Signal between two FX-modules with flip-side. Different CLK-signals recommended…

Sounds great with delays and reverbs.


You have two step-sequencers with CLK Input?

Maybe the same CLK-signal, but one with swing…

Think – sounds also great with step-sequencers.

It´s only one switch to hear the difference.


Use flip-sides with LFOs, ENVs, e.g.

You have a stereo filter with CV Inputs?

Now, you’ll get a more interresting stereo image by changing modulation on L + R s with one dualswitch by hand


Use flip-sides for stereo audio signal!

You have a eurorack stereo mixer?

And you mix different drum sounds hard panned?

Now you can easily change L + R channel mix using flip-sides!


Use flip-sides for stereo pad sounds, stereo reverbs !

You want to get the most out of your existing eurorack system?

Now you will get the most out of your patch by using flip-sides to change L + R channel!

It´s in your hands!

I love sounddesign!

 It´s not about panning.

It´s switching!

Something totally different.

 I use both,

LR MS MS LR IN MIND!

Close your eyes and listen!

Be aware of switching  sounds (2 channels  „ON“ at the same time, for 0,.. sec. or NOT  zero-voltage switching sound).

You can miss the sweet spot.. O .. it´s not DIVKIT MUTE… it´s an DUALSWITCH…passive. your are the master of sound!

OVERVIEW MODULES 2019

PASSIVE MODULES

ACTIVE MODULES